T-REX Sand Scoops
Stainless Steel 8" with 3/8" Holes Sand Scoop
Now with 1/4" holes on the bottom rear as well as halfway up
the rear wall to prevent the small treasures from falling through.
The top of the T-Rex scoop is about 5" deep to prevent targets from being knocked out of the scoop while hunting in the surf. Located on the top of the scoop there is a tube to attach your handle. The handle tube is angled at about 20 degrees so that digging is easier than with a straight up and down handle. This also makes the scoop more balanced and with a lighter feel when hunting out of water. The 3/8" holes are punched close together as to allow for quick sand release and to catch those smaller targets that can be missed by larger 1/2" or 5/8" holes. There is no push plate on the rear of this scoop. The lack of a push plate provides better control and balance when pushing down into the sand. The gauge of the stainless steel is .075" thick for the stress put on the scoop when digging in wet sand. Best of all it is made here in the U.S.A. (The T-REX requires a wooden handle that can be purchased at your local Home Depot/Lowes so there is no down time if you should break your handle.) Shaft size is 1 3/8" ID
Specs.
T-Rex Wet 8" Scoop:
Dimensions: 11" Long X 8" Wide X 4 5/8" Deep
Holes - 3/8" Square
Approx. Weight - 3 Lbs 7 oz
Shaft Tube: 1 3/8" ID
Handle Info: You can purchase an Ames 46" White Ash
Replacement Shovel Handle at any Home Depot.
Easy installation Instructions will be included with your T-Rex scoop.