T-REX Sand Scoops
8" T-Rex Stainless Steel Sand Scoop with 3/8" Honey Comb Holes
Now with 1/4" holes on the bottom rear as well as halfway up
the rear wall to prevent the small treasures from falling through.
The T-REX bucket is approximately 11” long by 9 1/2” wide and 4 7/8” deep. The top of the scoop is 5” deep to prevent targets from being knocked out of the scoop while hunting in the surf. On the top of the scoop is a tube to attach your handle. The Handle tube is angled at about 20 degrees so digging is easier than with a straight up and down handle. This also makes the scoop more balanced and feel lighter when hunting out of water. The 3/8” honeycomb holes are punched so that you can catch all targets large or small. The gauge of the stainless steel is .075” thick for the stress put on the scoop when digging in wet sand. The weight of the scoop is 4 lbs. on a postal scale (without the handle). Best of all it is made here in the U.S.A. (The T-REX requires a wooden handle that can be purchased at your local Home Depot so there is no down time if you should break your handle.)
T-Rex Wet 9.5" Scoop:
Dimensions: 11" Long X 9.5" Wide X 4 5/8" Deep
Holes - 3/8" Honey Comb
Approx. Weight - 4 Lbs
Shaft Tube: 1 3/8" ID
Handle Info: You can purchase an Ames 46" White Ash
Replacement Shovel Handle at any Home Depot.
Easy installation Instructions will be included with your T-Rex scoop.